SCE-90XMC2D18 - 2DR Center XM Enclosure

2DR Center XM Enclosure

Category: Free-Standing and Floor-Mounted Enclosures > Heavy Duty Free-Standing Enclosures for Flange-Mounted Disconnects (One through Six Door Enclosures) > Heavy Duty Free-Standing Center Enclosures

Specifications

Construction

• 0.125 in. carbon steel.
• Seams continuously welded and ground smooth.
• Flange trough collar around all sides of door opening.
• Body stiffeners in large enclosures for extra rigidity.
• Heavy duty lifting eyes anchor into reinforced top.
• Removable centerposts permit easy panel installation.
• Concealed hinges.
• Black zinc die cast padlocking handle on doors.
• 3-point latching mechanism.
• Ends of latch rods have ramp shoes for easier door closing.
• Panel supports.
• Pour in place oil & water resistant gasket
• Removable panels mount on collar studs.
• Ground stud on door and body.
• Provisions for light kit.
• Holes plugs provided to seal holes in bottom of enclosure.

Application

This enclosure is designed to be the center enclosure in a larger multi-door enclosure. Designed to house electrical equipment and provide protection from dirt, dust, oil and water and to house most standard type disconnects. For outdoor application a drip shield and drain vent is recommended. For details about the design, performance expectations, applications and design suggestions -

Finish

ANSI-61 gray powder coating inside and out. Sub-panels are powder coated white. Part numbers ending in "G" have galvanized subpanels installed.

Industry Standards - (IS3)

• NEMA Type 3R, 12 and Type 13
• UL Listed Type 3R and 12
• CSA Type 3R and 12
• IEC 60529
• IP 55

Notes

*Part numbers ending in "G" have galvanized sub-panels installed. Special Instructions apply for IS3, IS4 and IS6 to maintain the environmental rating of Type 3R